RAINGUARDPRO® DECK-LOK ™ is a vapor permeable interior/exterior 100% acrylic latex paint. The excellent adhesion, durability, and resistance to alkalinity makes this an ideal all purpose and floor finish for all wood, masonry, and asphalt surfaces. The durable latex film dries to a soft low sheen finish and may be walked on in 24 hours, depending on drying conditions.
IMPORTANT: NOT FOR USE ON AREAS WITH HOT TIRE TRAFFIC
- Decks and patios
- Walls and floors
- Swimming pool areas
- Wooden fences and gates
Coverage Rates (Theoretical)*
|Substrate||Sq Ft / Gallon|
|Wood||200 – 400|
|Concrete||100 – 400|
|Masonry||100 – 400|
|Asphalt||150 – 300|
|Metal||200 – 400|
*Coverage rates differ dramatically between smooth and textured Deck-Lok™. Please refer to TDS below.
How to Use*
*SEE TECHNICAL DATA SHEET BELOW FOR FURTHER INSTRUCTIONS BEFORE APPLICATION
- Before product is applied, surface must be clean and dry. All surfaces must be free of dirt, grease, wax, mildew, chalk, loose peeling paint or any other contaminants. Deck-Lok™ is ready to use out of the can. If thinning is required use a small amount of water. For best results two coats of Deck-Lok™ are recommended.
New and/or unpainted surfaces should be properly primed with a primer such as RainguardPro® Micro-Seal® before applying Deck-Lok™.
Apply at outdoor temperatures between 55°F – 100°F. Deck-Lok™ may be applied by using:
Brush – synthetic or nylon bristled brush
Roller – 1/4” nap for smooth surface or 3/8” to 1/2”nap for rough surfaces
To avoid lap marks, maintain a continuous wet edge. Feather edges at the end of each pass. Stop application only at control joints, corners, and edges. Back rolling may be necessary to even the applied finish.